Head Didn't Return to the Rear Left Corner

Glowforge Performance Series Performance Series


Rarely, your Glowforge might move the black laser head against the side of the rail instead of moving to the center, making a banging noise. This won’t harm anything, but might prevent your Glowforge from printing.

If this happens, please:

  • Turn off your Glowforge (this is important to avoid damage to your unit)
  • Open the lid and, using both hands, gently move the laser arm to the center of the bed
  • Gently move the head under the lid camera
  • Turn your Glowforge back on

Was this article helpful?